POWER SAVER UNITS . SAVE MONEY on your ELECTRIC BILL.

 

 

Call 215-7225993 for Installation

How Does it Work?

When a motor in your home starts, it asks your utility company's transformer for power.  The demand of electricity from your motor runs through the wiring in your home, to the panel box, traveling to your meter, finally reaching its destination of the transformer and back down to your home again.  Throughout this process, the lines/wiring heats up and strains the motor and wiring.  The heat generated is called watts.

During a normal electrical process, there is lost energy that you are being billed for by your energy company but are not able to use.

The Electric Saver stores (otherwise lost energy/watts) and releases energy to your motor when needed to function properly.  This reduces the amount of heat on the wires and the motors in your home.  Reducing this heat will lower your electricity bill and increase the life of your motors in your home. Inductive Motors are in your Refrigerator, Freezer, Washer, Dryer, Ceiling Fans, Air Conditioning Units, etc.  If you use the old T-12 Fluorescent Lighting, the ballast is also an inductive load.  Anything with a copper winding that creates an electromagnetic field is an inductive load, just like your inverter that turns DC current into AC current.

Using methods from large industrial complexes, The Electric Saver reclaims wasted energy and recycles electrical energy.  It protects against power surges and increases the capacity to your electrical panel by causing it to run cooler.  By doing so, this saves you money $$$$$!

"Over 16 Billion Dollars of Electricity is unusable energy, but billable in the U.S."
US Department of Energy
 

How I know it Works?


Transformer
It is an inductive load for your power company, just like the motors in your home (A/C, Refrigerators, etc.), this is your power companies inductive loads.  
 
These are the capacitors your power company uses to correct their power factors. When you correct the power factor, it reduces demand. The electric meter on the side of your home that your electric company reads is a demand meter. With the proper use of capacitors, you can reduce demand and legally slow down your meter. Your electric company has been using this very same technology for 70+ years to correct their power factors. Now why would your power company spend tens of thousand of dollars on a capacitor bank to correct their power factor if it doesn't work?
BECAUSE IT DOES WORK!
If you look around your neighborhood on the power poles, for about every 50 transformers, you will notice 1 of these banks of capacitors correcting the power factors of the transformers in your neighborhood.

High Voltage Pole Mount Capacitor
 

How Many Do I Need?

Usually a home needs 1 unit.  The Electric Saver 1200 works up to 200 amps.  If you are unsure, check your panel box.  If your main breaker is 200 amps or less, you will need only 1 unit.

  • SAVE UP TO 25% on your Electric Bill! Average Savings is 10-12%

  • The Electric Saver 1200 does the same thing as the KVAR PU 1200 & Power Save 1200 at 1/4 the price!

  • 20 Year Warranty on Workmanship & Product Defects

  • Comes with Easy to Follow Installation Instructions. 

  • Made in USA-Manufactured in Miami, FL

  • 100% Satisfaction Guaranteed or your money back so you have NOTHING to lose!

 

Back to HomePage